Hyundai H-1 2005 Owner's Manual page 110

D060F02P-GAT
5. Raising the Car
Minibus/Van Truck
E020A01P
Open the lid at the right corner of the
luggage compartment (minibus/van)
or on the floor behind the seat (truck).
Loosen the securing nut, and then take
out the jack.
CORROSION PREVENTION AND APPEARANCE CARE
Ram
Pressure
piston
Jack handle
HAUT408
Using the jack handle, turn the release
valve clockwise until it reaches a stop.
Notch of
holder
HAUT405
Then fit the jack handle into the holder,
and align the groove of the jack handle
with the notch of the holder.
IN CASE OF EMERGENCY
HAUT406
Move the jack handle up and down to
raise the ram until just before the jack
contacts the jacking point of the car.
Position the jack with the jack handle.
Position it only at the specified points
indicated in the "Put the Jack in Place".
Use of the jack at other points could
damage the car.
Moving the jack handle up and down to
raise the ram.
As the jack begins to raise the vehicle,
double check that it is properly posi-
tioned and will not slip.
4 4
9 9