Illuminated Ignition Switch - Hyundai H-1 2005 Owner's Manual

NOTE:
You can get the limp home pass-
word when the vehicle is first deliv-
ered to you. If you do not have the
password, consult your authorized
Hyundai dealer.
1. To set the password you may turn
the ignition key "ON" and then turn
it "OFF" according to the digit num-
bers, then the immobilizer indicator
will blink along with the operation of
the ignition key. For example, turn
the ignition key once for digit num-
ber "1", and twice for "2", and so on.
However, for the digit number "0",
you must turn the ignition key for 10
times.
2. Wait for 3~10 seconds.
3. You may set the remaining number
of digits by following the same pro-
cedures 1 and 2.
4. If all of four digits have been tried
successfully, turn the ignition key
"ON" and check that the immobi-
lizer indicator illuminates. From this
time, you have to start your engine
within 30 seconds. If you start your
engine after 30 seconds, your en-
gine will not start.
NOTE:
If the engine dies while driving after
limp home procedure, you can start
your engine within 8 seconds with-
out limp home procedure again.
5. If the immobilizer indicator blinks for
five seconds, you have to try the
limp home procedure again from
the beginning.
After doing the limp home procedure,
you have to consult with your autho-
rized Hyundai dealer as soon as pos-
sible.
!
CAUTION:
o If you fail to try the limp home
procedure with the sequence of
three times, you have to wait for
about one hour to do the limp
home procedure again.
o If you cannot start your engine in
spite of limp home procedure,
have your vehicle towed by an
authorized Hyundai dealer.
BEFORE DRIVING YOUR VEHICLE
ILLUMINATED IGNITION
SWITCH
B120A02P-GAT
(If installed)
B120A02P
Whenever a front door is opened, the
ignition switch will illuminate for your
convenience.
The light will go off when the ignition
switch is turned on or 10 seconds after
closing the door.
1
11