Ipv4 Firewall-Add Rule Screen - ZyXEL Communications ARMOR G1 NBG6818 User Manual

Table 42 Settings > Firewall > IPv4 Firewall (continued)
L ABEL
Dest IP Address
Source IP Address
Dest Port Range
Source Port Range
Protocol
Actions
Apply
Cancel
12.2.1 IPv4 Fire wa ll- Add Rule Sc re e n
Use this screen to configure IPv4 firewall rule. Click
the following screen.
Settings > Firewall > IPv4 Firewall > Add Rule
Fig ure 74
Chapter 12 Security
DESC RIPT IO N
This is the IP address of the computer to which traffic for the application or service is entering.
This is the IP address of the computer from which traffic for the application or service is
initialized.
This is the port number/range of the destination that define the traffic type, for example TCP
port 80 defines web traffic.
This is the port number/range of the source that define the traffic type, for example TCP port
80 defines web traffic.
This is the protocol ( ,
T C P UDP
apply the firewall rule.
Click to remove the firewall rule.
Click to edit the firewall rule.
Click to save the settings.
Apply
Click to start configuring this screen again.
C a nc e l
NBG6818 User's Guide
126
or ) used to transport the packets for which you want to
IC MP
> >
Se tting s Fire wa ll
>
IPv4 Fire wa ll Add Rule
to open