Spurious Emissions At Antenna Connector; Residual Peak Power; Rx Characteristics; Sensitivity - Panasonic EB-X100 Service Manual

4.1.5. Spurious Emissions at Antenna Connector

Frequency Range
100 kHz to 50 MHz
50 MHz to 500 MHz
500 MHz to 1 GHz
1 GHz to 12.75 GHz
Excl. relevant TX band
E-GSM : 880 MHz to 915 MHz
DCS : 1710 MHz to 1785 MHz
-and the Rx bands
925 MHz - 960 MHz
1805 MHz - 1880 MHz
Relevant TX band:
E-GSM : 880 MHz to 915 MHz
DCS : 1710 MHz to 1785 MHz

4.1.6. Residual Peak Power

Equal to or less than 70 dBc (BW = 300 kHz)

4.2. Rx Characteristics

4.2.1. Sensitivity

E-GSM 900 Full Rate Speech
The reference sensitivity performance in terms of frame erasure, bit error, or residual bit error rates (whichever is
appropriate) is specified in the following table, according to the propagation conditions.
Channels Propagation conditions
Test Limit
error rate
6.742* α
TCH/FS FER
0.42/ α
class Ib (RBER)
class II (RBER) 8.333
The reference sensitivity level is < –104 dBm.
NOTE : 1 < α < 1.6. The value of a can be different for each channel condition but must remain the same for FER and class
1b RBER measurements for the same channel condition.
Frequency
offset
–
–
0 to 1 MHz
0 to 10 MHz
> 10 MHz
> 30 MHz
(off from edge of
relevant Tx band)
1.8 to 6.0 MHz
> 6.0 MHz
Propagation conditions
TU high
Minimum Test Limit
No of error rate
% samples %
8,900
1,000,000
120,000 7.5
Filter Approx
Bandwidth Video B/W
10 kHz 30 kHz
100 kHz 300 kHz
100 kHz 300 kHz
100 kHz 300 kHz
300 kHz 1 MHz
3 MHz 3 MHz
30 kHz 100 kHz
100 kHz 300 kHz
Propagation conditions
RA HT
Minimum Test Limit
No of error rate
samples %
24,000 9.333
– 4-2 –
Limits (dBm)
E-GSM 900 GSM1800
–36 –36
–36 –36
–36 –36
–30 –30 (1.0 - 1.710 GHz)
–30
–30 –36 (1.710 - 1.785 GHz)
–30 (1.785 - 12.75 GHz)
–36 –36
–36 –36
Static Conditions
Minimum Test Limit
No of error rate
samples %
0.122* α
0.41/ α
60,000 2.439
Minimum
No of
samples
164,000
20,000,000
8,200