Ptz Control - Clover CDR-4170 Instruction Manual

7. PTZ CONTROL

1. Connect Pan/Tilt/Zoom camera's control to RS485(+) / RS485(-) port on the rear of the system.
2. The video output of Pan/Tilt/Zoom camera to the one out of channel you wish to connect.
3. Press and hold the PTZ button for about 3 seconds on the front panel and the PAN/TILT
CONTROL screen will be displayed on the monitor.
4. Can select the order for control that user wants to do whenever ENTER button is pressed.
MOVE: Change the position of screen shown on Pan/Tilt Zoom camera.
ZOOM: Change zoom in/out value of the screen shown on Pan/Tilt Zoom camera.
FOCUS: Change focus value of the screen shown on Pan/Tilt Zoom camera.
CH SEL: Select the channel that is connect to Pan/Tilt Zoom camera.
5. After finishing setup, Press the ESC button to exit.
• Connect only one Pan/Tilt/Zoom camera on the system.
NOTE • The protocol of P/T/Z camera should be Pelco-D Protocol.
• The baud rate of P/T/Z camera must be 2,400bps (bit per second).
ORDER
CAMERA TITLE
- 40 -