Clover CDR-4170 Instruction Manual page 30

5.4.4 MOTION HOLD
•
Choose the MOTION HOLD in the MOTION menu with the UP/DOWN buttons
•
Press the ENTER Key button to set up the MOTION HOLD..
•
Choose the time duration (1sec. ~ 15sec.) with UP / DOWN key buttons
•
After set-up the time duration, press the ENTER Key.
•
Press the ESC button to exit.
5.4.5 AREA
•
Choose the AREA in the MOTION menu with the UP/DOWN buttons
•
Press the ENTER button to create the motion detection AREA.
•
Move the symbol "O" by using the UP / DOWN / LEFT / RIGHT buttons and select the
area where you would like to create, and press the ENTER button.
•
To release the motion detection area, press the ENTER button after moving the symbol
"O" to the same area where you created.
•
Press the ESC button to exit.
The OSD or OSD+BUZZER and the motion detection AREA should be selected
NOTE
for motion recording.
The system will not save recorded data to the Hard Disk Drive (HDD) when the unit is set to the
improper recording mode (endless motion detection). To correct this, change the recording mode
to the Continuous Recording mode for most applications.
Please pay attention to the following directions in order to use the Motion Detection function
properly:
•
Adjust the sensitivity level and motion area to fit your requirements.
•
Do not use this function in an area where many objects are continuously moving. In case
of this, change the recording mode to the Continuous Recording mode.
•
Use a high quality camera that does not generate video static or "noise". The motion
detection algorithm recognizes this "noise" as a motion and records the noise even if
there was no actual motion.
•
Do not point the camera toward a strong and changing lighting source; it can activate a
false motion detection.
- 25 -
Created Motion
detection area