Be sure that the jumper setting is correct. If not, the system will not recognize the
NOTE
additional HDD (SLAVE).
4. Secure the HDD with the supplied screws as below.
5. Connect the power connector and the flat cable to the HDD.
Be sure that the power connector and the flat cable are properly connected.
NOTE
6. Reassemble the cover.
7. Turn the power on and see if the HDD is being recognized.
After installing the additional HDD, formatting the new HDD should be performed.
NOTE
See 5.5.2 Hard Drive for more details.
- 39 -
FIX SCREW