Basic Engine - MULTIQUIP Mikasa Series Operation And Parts Manual

The engine (Figure 3) must be checked for proper
lubrication and filled with fuel prior to operation. Refer
to the manufacturer's engine manual for instructions and
details of operation and servicing.
1. Choke Lever — Normally used in starting the engine
in cold weather conditions. In cold weather, turn
the choke lever to the fully closed position. In warm
weather, set the choke lever halfway or completely
open.
2. Engine ON/OFF Switch — Controls the starting and
stopping of the engine. Switch must be in the "ON"
position when starting the engine.
3. Spark Plug — Provides spark to the ignition system.
Set spark plug gap to 0.024 - 0.028 inch (0.6 - 0.7 mm).
Clean spark plug once a week.
4. Recoil Starter (pull rope) — Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
NOTICE
Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement
will allow dirt to enter the engine, causing rapid engine
wear.
PAGE 14 — MTR40HF RAMMER • OPERATION AND PARTS MANUAL — REV. #0 (09/14/17)
Figure 3. Honda GX100RTKRB6 Engine
5. Muffler — Used to reduce noise and emissions.
6. Dipstick/Oil Filler Cap — Remove this cap to
7. Oil Drain Plug — Remove this plug to remove oil from

BASIC ENGINE

determine if the engine oil is low. Add oil through this
filler port as recommended in Table 4.
the engine's crankcase.
WARNING
Engine components can generate
extreme heat. To prevent burns, DO
NOT touch these areas while the
engine is running or immediately
after operating. NEVER operate the
engine with the muffler removed.