Basic Engine - MULTIQUIP Mikasa Series Operation And Parts Manual

Tamping rammer
Hide thumbs Also See for Mikasa Series:
Table of Contents

Advertisement

The engine (Figure 2) must be checked for proper lubri-
cation and filled with fuel prior to operation. Refer to the
engine manufacturer's manual for detailed operation and
service information.
1. Choke Lever — Normally used in starting the engine in
cold weather conditions. In cold weather, turn the choke
lever to the fully closed position. In warm weather, set
the choke lever halfway or completely open.
2. Spark Plug — Provides spark to the ignition system.
Set spark plug gap to 0.024 - 0.028 inch (0.6 - 0.7 mm).
Clean spark plug once a week.
3. Muffler — Used to reduce noise and emissions.
4. Dipstick/Oil Filler Cap — Remove this cap to
determine if the engine oil is low. Add oil through this
filler port as recommended in Table 3.
NOTICE
Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement
will allow dirt to enter the engine, causing rapid engine
wear.
PAGE 14 — MTX80HDR RAMMER • OPERATION AND PARTS MANUAL — REV. #2 (10/26/18)
1
2
6
Figure 2. Honda GXR120RT-KRBF Engine
3
4
5
5. Oil Drain Plug — Remove this plug to remove oil from
the engine's crankcase.
6. Recoil Starter (pull rope) — Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
WARNING
Engine components can generate
extreme heat. To prevent burns, DO
NOT touch these areas while the
engine is running or immediately
after operating. NEVER operate the
engine with the muffler removed.

BASIC ENGINE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mtx80hdr

Table of Contents