Nameplates And Decals Assembly - MULTIQUIP Mikasa Series Operation And Parts Manual

CAUTION
Before Operation
Check all nuts and bolts for tightness
Keep machine at the upright operating position to check
1. Give each grease fitting five (5) shots of grease with
a hand grease gun.
2. Check the engine oil level and if the level is low,
it should be refilled from the filler hole.
NPA-1100 J
2D
GREASE
GREASE
14
MODEL
SERIAL NO.
SECONDARY AIRFILTER
SERVICE MONTHLY
PAGE 28 — MTR40HF RAMMER • OPERATION AND PARTS MANUAL — REV. #0 (09/14/17)
NAMEPLATES AND DECALS ASSY.
1
OPERATION
To START engine:
Open fuel filter valve and close choke lever on carburetor.
Place starter switch to "ON" and pull start rope.
When engine starts, open the choke lever and warm up the
engine for 4-5 minutes before operation.
Then move throttle lever from "OFF" to "ON" to operate.
To STOP engine:
Move the throttle lever quickly from "ON" to "OFF" position.
Then move starter lever quickly to "OFF" and close the fuel filter valve.
Oil
öl
I' huile
SAE30
7~9 cc
NPA-961 E
11
3800 ~ 4100 RPM
NPA-957 J
10
NP-120
12
10
NP-120
2E
9
MEETS U.S. EPA EVAP STANDARDS
USING CERTIFIED COMPONENTS
MIKASA SANGYO CO., LTD
NPA-1676 J
8
NPA 1016 J
2A
2B
2C
3
PRIMARY AIRFILTER
CHECK DAILY
NPA 1018 J
10
GREASE
NP-120
2B
13
Operation of this equipment may create
sparks that can start res around dry vegetation.
A spark arrestor may be required.
The operator should contact local re agencices
for laws or regulations relating to re prevention
requirements.
NPA-1410
2
2F
2G
2D
2E
72
2C
72
5
GASOLINE ONLY
NPA 1017 J
6
NPA-1169 J
NPA-1087 E
ISO3864
2A
7