Components - MULTIQUIP Mikasa Series Operation And Parts Manual

1
3
4
5
SIDE A
6
7
Figure 2 shows the location of the controls and components
for the MTR40HF Tamping Rammer. The functions of each
control is described below:
1. Lifting Hook — Used to lift rammer for transporting.
2. Throttle Lever — Used to adjust engine speed (rpm).
Move lever forward (SLOW) to reduce engine speed,
move lever back toward operator (FAST) to increase
speed.
3. Nameplate — Displays information regarding the
rammer.
4. Engine Air Cleaner — Prevents dirt (second stage)
and other debris from entering the engine.
5. Grip — When transporting the rammer, carry it by
gripping the handle.
6. Dust Sleeve — Prevents dust and debris from entering
into the spring cylinder.
7. Foot — Laminated wood with tempered steel plate for
superior shock absorption.
8. Zerk Fittings (4) — Lubricates main springs and
crankcase bearings.
MTR40HF RAMMER • OPERATION AND PARTS MANUAL — REV. #0 (09/14/17) — PAGE 13
9
2
11
12
SIDE B
8
Figure 2. MTR40HF Rammer
10
14
13
15
9. Fuel Tank/Cap — Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely. DO NOT over fill.
10. Fuel Shut-Off Valve — Supplies fuel from the fuel tank
to the engine. To begin fuel flow, move the fuel shut-off
valve downward.
11. In-Line Fuel Filter — Prevents dirt and debris from
entering the fuel system.
12. Engine — This unit uses a Honda GX100RTKRB6
gasoline engine. Reference Table 3 for detailed
specifications.
13. Muffler — Used to reduce noise and emissions.
14. Shock Absorber — Reduces vibration due to the
tamping action.
15. Primary Air Cleaner — Pre-cleans (first stage) dirt
and other debris from entering the engine.
16. Handle — To operate rammer, GRIP handle firmly on
both sides.

COMPONENTS

8
TOP
16