Basic Engine - MULTIQUIP Mikasa Series Operation And Parts Manual

4
The engine (Figure 2) must be checked for proper lubri-
The engine (Figure 2) must be checked for proper lubri-
cation and filled with fuel prior to operation. Refer to the
cation and filled with fuel prior to operation. Refer to the
engine manufacturer's manual for detailed operation and
engine manufacturer's manual for detailed operation and
service information.
service information.
1. Choke Lever — Normally used in starting the engine in
1. Choke Lever — Normally used in starting the engine in
cold weather conditions. In cold weather, turn the choke
cold weather conditions. In cold weather, turn the choke
lever to the fully closed position. In warm weather, set
lever to the fully closed position. In warm weather, set
the choke lever halfway or completely open.
the choke lever halfway or completely open.
2. Spark Plug — Provides spark to the ignition system.
2. Spark Plug — Provides spark to the ignition system.
Set spark plug gap to 0.024 - 0.028 inch (0.6 - 0.7 mm).
Set spark plug gap to 0.024 - 0.028 inch (0.6 - 0.7 mm).
Clean spark plug once a week.
Clean spark plug once a week.
3. Recoil Starter (pull rope) — Manual-starting method.
3. Recoil Starter (pull rope) — Manual-starting method.
Pull the starter grip until resistance is felt, then pull
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
briskly and smoothly.
NOTICE
NOTICE
Operating the engine without an air filter, with a
Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement
damaged air filter, or a filter in need of replacement
will allow dirt to enter the engine, causing rapid engine
will allow dirt to enter the engine, causing rapid engine
wear.
wear.
4. Muffler — Used to reduce noise and emissions.
4. Muffler — Used to reduce noise and emissions.
MTX60SF RAMMER • OPERATION AND PARTS MANUAL — REV. #1 (06/21/19) — PAGE 13
MTX60SF RAMMER • OPERATION AND PARTS MANUAL — REV. #0 (03/01/13) — PAGE 13
5
Figure 2. Robin ER120D45010 Engine
Figure 2. Robin ER120D45010 Engine
1
5. Dipstick/Oil Filler Cap — Remove this cap to
5. Dipstick/Oil Filler Cap — Remove this cap to
determine if the engine oil is low. Add oil through this
determine if the engine oil is low. Add oil through this
filler port as recommended in Table 3.
filler port as recommended in Table 3.
6. Oil Drain Plug — Remove this plug to remove oil from
6. Oil Drain Plug — Remove this plug to remove oil from
the engine's crankcase.
the engine's crankcase.
WARNING
WARNING
Engine components can generate
Engine components can generate
extreme heat. To prevent burns, DO
extreme heat. To prevent burns, DO
NOT touch these areas while the
NOT touch these areas while the
engine is running or immediately
engine is running or immediately
after operating. NEVER operate the
after operating. NEVER operate the
engine with the muffler removed.
engine with the muffler removed.

BASIC ENGINE

BASIC ENGINE
2
3
6