Page 1
OPERATION MANUAL SERIES MODEL MVHeR60 REVERSIBLE PLATE COMPACTOR (HONDA GXE2.OH DC POWER UNIT HONDA DP72104Z BATTERY) Revision #0 (02/09/22) To find the latest revision of this publication or associated parts manual, visit our website at: www.discount-equipment.com THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
Page 2
@ www.discount-equipment.com Select an option below to find your Equipment We sell worldwide for the brands: Genie, Terex, JLG, MultiQuip, Mikasa, Essick, Whiteman, Mayco, Toro Stone, Diamond Products, Generac Magnum, Airman, Haulotte, Barreto, Power Blanket, Nifty Lift, Atlas Copco, Chicago Pneumatic, Allmand, Miller Curber, Skyjack, Lull,...
SAFETY INFORMATION Do not operate or service the equipment before reading Potential hazards associated with the operation of this the entire manual. Safety precautions should be followed equipment will be referenced with hazard symbols which at all times when operating this equipment. may appear throughout this manual in conjunction with Failure to read and understand the safety safety messages.
Page 5
NEVER use accessories or attachments that are not NEVER operate this equipment when not recommended by Multiquip for this equipment. Damage feeling well due to fatigue, illness or when to the equipment and/or injury to user may result.
Page 6
SAFETY INFORMATION COMPACTOR SAFETY TRANSPORTING SAFETY DANGER CAUTION NEVER operate the equipment in an explosive NEVER allow any person or animal to stand underneath atmosphere or near combustible materials. An the equipment while lifting. explosion or fi re could result causing severe NOTICE bodily harm or even death.
SPECIFICATIONS Table 1. MVHeR60 Specifications Centrifugal Force 2,698 lbf (12 kN) Vibration Frequency 6500 vpm (108 Hz) Lubrication Oil API Service Categories SE or higher SAE 10W-30 Plate Size (L x W) 18.9 x 13.8 in (480 x 350 mm) Maximum Travel Speed 0 to 78.7 ft/min (0 to 24 m/min) Operating Weight...
Page 9
SPECIFICATIONS Table 4. Battery Charger Specifications Model Honda CV7285Z Dimensions (L x Wx H) 10.5 x 13.9 x 9.7 in (266 x 352 x 247 mm) Weight 24.2 lbs. (11 kg) Cable Length 78.7 in (2000 mm) Input Voltage 100-240 VAC Input Frequency 50/60 Hz Output Voltage...
GENERAL INFORMATION DEFINITION OF PLATE COMPACTOR VIBRATORY PLATES The Mikasa MVHeR60 is a walk-behind, reversible plate The vibratory plates produce low amplitude high frequency compactor designed for the compaction of sand, mixed vibrations, designed to compact granular soils and soils and asphalt. This plate compactor is a powerful asphalt.
Page 13
COMPONENTS 8. Switch Box — contains buttons and indicators to Figure 2 shows the location of the basic controls and operate compactor. components of the MVHeR60 Plate Compactor. The function of each control is described below: 9. Vibration Case — Encloses the eccentric, gears and 1.
Page 14
POWER UNIT Figure 3. Power Unit Components 1. Battery Connector Cap — Protects the battery 5. Battery Support — Where the battery pack sits on connector on the power cable. the battery tray. 2. Power Cable — Connects the compactor to the battery 6.
INSPECTION BEFORE STARTING BATTERY PACK AND BATTERY CHARGER NOTICE 1. Read safety instructions at the beginning of manual. Follow the owner’s manual provided with the battery 2. Clean the compactor, removing dirt and dust. pack and battery charger for the following operations: 3.
Page 16
INSPECTION 2. Tilt the battery pack and insert its claw into the battery 7. After attaching the battery pack, make sure the battery hook. hook and fastener are securely attached. 3. Push down the battery pack and hook the battery Removing the Battery Pack fastener to it (Figure 6).
OPERATION CAUTION NOTICE Failure to understand the operation of the plate • If the POWER button is pressed when the START/ compactor could result in severe damage to the unit STOP switch is in the START position, the POWER or personal injury. indicator remains off and the ALERT indicator flashes.
Page 18
OPERATION WATER TANK (OPTIONAL) 1. If your unit is equipped with the water tank and your application requires sprinkling work, open the cock of water tank(Figure 10). Figure 10. Water Tank Cock (Open) 2. When stopping sprinkling work, close the cock of water tank (Figure 11).
MAINTENANCE DAILY INSPECTION CAUTION 1. Check for leakage of fuel or oil. Inspection and other services should always be carried out on hard and level ground with the engine shut down. 2. Check for loose screws including tightness. See Table 9 (Tightening Torque) for retightening. INSPECTION AND MAINTENANCE TABLES Table 9.
Page 20
MAINTENANCE 1. Check the hydraulic oil at every 100 hours of operation. 2. Place the handle bar in vertical position. 3. Remove the breather plug at the top of the hydraulic hand pump to see if the hydraulic oil is at the specified level.
MAINTENANCE/LONG TERM STORAGE CHECKING SWITCH BOX 1. Check that the assembly of switch box is not loose (Figure 16). 2. If switch box is loose, it may fall off or be damaged. 3. If loose, remove the switch box and replace the grommet installed on switch box panel with a new one.
TROUBLESHOOTING Troubleshooting (Compactor) Symptom Possible Problem Solution Clutch slips? Adjust or replace clutch. V-belt slips? Adjust or replace V-belt. Excessive oil in vibrator? Fill to correct level. Check vibrator assembly for any Travel speed low and vibration Trouble in vibrator internals? worn or defective parts, replace any weak.