Table of Contents
Advertisement
4.1.3 Fitting the battery backpack
The battery backpack is delivered already
assembled
(Fig.
1.G) and can be released from
the strap support (Fig. 5) and carried by hand.
To release the battery backpack, press
on the two upper buttons (Fig. 5.A).
The battery compartments are located on
both sides of the backpack (Fig. 6).
The following can be found on the
right side of the backpack:
• cable socket (Fig. 7.A)
• battery selector (Fig. 7.B)
• one USB port for charging other devices
(e.g. mobile phones) (Fig. 7.C)
To avoid any loose cables, there are
grooves on both sides and at the rear, in
which the power cable can be inserted.
5. CONTROLS
5.1 THROTTLE CONTROL LEVER
The machine is started/stopped by operating
the throttle control lever (Fig. 8.A).
For machine start up:
1. press the throttle control lever.
2. adjust the speed based on
the pressure applied.
The machine stops automatically as the
throttle control lever is released.
6. USING THE MACHINE
DANGER
The safety regulations to be followed are
described in chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
6.1 PRELIMINARY OPERATIONS
Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
1. place the machine in a stable
horizontal position on the ground;
2. check the battery (par. 6.1.1);
3. Insert the battery correctly in
one of the compartments of the
battery backpack (par. 7.2.3 );
4. Wear the
battery backpack
correctly (par 6.1.2).
6.1.1 Checking the battery
The machine is supplied without the battery.
Purchase the battery with the capacity that
most suits your operational requirements
and fully charge it according to the
instructions in the battery charger manual.
The list of approved batteries for this machine
can be found in the "Technical Data" table.
NOTE
Before each use: Check the battery
charge status by following the instructions
provided in the battery charger manual.
6.1.2 Using the battery backpack
1. Insert the battery in one of the compartments
of the battery backpack and push it
completely, until hearing the click that
signals its locking in position, ensuring
thus the electrical contact (Fig. 6).
2. Connect the cable to the specific socket
and rotate it until hearing the specific click
that signals its locking in position, ensuring
thus the electrical contact (Fig. 7.A).
3. Adjust the straps (Fig. 9.A).
4. Close the harness at the front (Fig. 9.B).
5. Connect the cable to the machine (Fig. 10).
6. Select the battery to be used (Fig. 7.B).
6.2 SAFETY CHECKS
Run the following safety checks and
ensure that the results correspond
to those outlined in the tables.
DANGER
Always carry out the safety checks before
use. If any of the results fail to match the
indications provided in the tables below, do not
use the machine! Take it to a service centre
to be checked and repaired if necessary.
EN - 10
Advertisement
Table of Contents
