Table of Contents
Advertisement
• Never use the machine
with damaged, missing or
incorrectly positioned
• Never disengage, deactivate,
remove or tamper with
the safety systems/micro
switches installed.
• Do not use the power tool
if the switch does not turn it
on and off. Any power tool
that cannot be controlled
with the switch is dangerous
and must be repaired.
• Do not strain the machine
too much and do not use a
small machine for heavy-
duty work; if you use the right
machine, you will reduce the
risk of hazards and improve
the quality of your work.
2.4 MAINTENANCE,
STORAGE
Ensure regular maintenance
and correct storage to
maintain machine safety and
high performance levels.
Maintenance
• Never use the machine with
worn or damaged parts.
Faulty or worn-out parts
must always be replaced
and never repaired.
• Cleaning and user
maintenance shall not be made
by children without supervision.
DANGER
The noise and vibration levels
shown in these instructions
are the maximum levels when
using the machine. Suitable
preventive measures must be
guards.
adopted to eliminate possible
harm caused by high noise
levels and vibration-induced
stresses; utilise the machine
at constant speed, firmly hold
the handgrip with adequate
strength, utilise the machine
at the minimum speed
required to perform the work,
wear ear-protection devices,
make frequent and adequate
pauses during the work.
Storage
To reduce fire risks, do
not leave containers with
debris inside a room.
The following safety rules
complement the safety
rules contained in the
battery charger manual.
• Only use battery chargers
• Use only batteries specifically
EN - 5
2.5 BATTERY / BATTERY
CHARGER
ATTENTION
recommended by the
manufacturer to recharge
batteries. An inadequate
battery charger may cause
electric shock, overheating
or corrosive liquid to
leak from the battery.
designed for your power tool.
The use of other batteries may
cause injuries and fire risks.
Advertisement
Table of Contents
