Table of Contents
Advertisement
ATTENTION
State the identification data on the product
identification label whenever you contact
an Authorised Service Centre.
NOTE
An example of the Declaration of Conformity
is provided on the last pages of this manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Power unit: it drives the rotor.
B. Blower tube: it is the component through
which the air flow is discharged.
C. Handgrip: it makes it possible
to control the machine.
D. Battery backpack (attachment
on request, par. 14.3): device in
which the batteries are placed.
E. Batteries (accessory available upon
request, paragraph 14.1): device that
supplies electric current to the tool.
F.
Battery charger (accessory available
upon request, paragraph 14.2): device used
to recharge the battery; its specifications
and regulations for use are described
in a specific manual. Three battery
charger models are available: F1 (fast
battery charge); F2 (standard battery
charge); F3 (dual battery charge).
G. Connection cable: cable used to connect
the machine to the battery backpack.
4. ASSEMBLY
DANGER
The safety regulations to be followed are
described in chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
ATTENTION
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for moving the machine
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the instructions provided in the
"ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
DANGER
Before assembly, check that the machine is
not connected to the battery backpack.
4.1.2 Assembly / disassembly
of the blower tube
1. Align the locking device (Fig.3.A)
with the protrusion (Fig. 3.B) on
the air outlet (Fig. 3.C).
2. Push the tube (Fig. 3.D) until it hooks
up firmly with the drive unit with a
"click" when it locks in place.
To remove the tube, press the button
(Fig. 3.A) and then slide it out.
DANGER
Stop the machine and disconnect it
from the battery backpack (Fig. 4) each
time the blower tube is removed.
EN - 9
Advertisement
Table of Contents
