Citizen iDP-460 User Manual page 53

ESC d
[Name]
[Code]
[Function]
[Caution]
[See Also]
ESC e (n) ;
[Name]
[Code]
[Domain]
[Function]
[Caution]
Request Printer Status
<1B>H<64>H
In the P-250 mode and P-900R mode, this command sends the following 1-byte status
messages shown below.
Bit Code
0 L
1 X
2 X
3 X
4 X
5 1
6 F
7 P
This command is ignored for the parallel interface and in the P-200 mode.
runs out or there is a mechanical error, the data may not be received.
ESC a
Set Right Margin
<1B>H<65H>(n)<3B>H
0 (n) 42 (<30>H n <39>H)
In the P-250 mode and P-900R mode, this command controls whether the characters
should be printed or at which position of the line they should be printed, when the buffer
is full. When the parameter is set between 1 and 41, the printer will print automatically
when the n-th printable character is received. If the parameter is set beyond these limits,
printing will be performed when the LF command is received.
Be sure to add ";"(<3B>H) to the end of the parameter.
other than the P-250 mode and the P-900 mode.
This command is valid only for the serial interface.
Function
Paper end
Not defined
Not defined
Not defined
Not defined
Unused
Mechanical error
Parity
39
iDP-460 User's Manual
Value
0
With paper
- -
Without error
Fixed at 0
This command is ignored in
P-250, P-900R
1
Without paper
Fixed at 1
With error
- -
If the paper
P-250, P-900R
CITIZEN