Citizen iDP-460 User Manual page 50

[Function]
[See Also]
S1
[Name]
[Code]
[Function]
[Caution]
[See Also]
1. Serial interface 7-bit setting
High pages are specified in all the modes.
codes 20H to 7FH will be converted into A0H to FFH.
until the SI command or CAN command is received.
2. Serial interface 8-bit setting and parallel interface
This command is ignored in the P-250 mode and P-900R mode.
it sets the double width characters(same as the RS command <IE>H).
subsequent characters as double width characters.
When there is only one character worth of position in a line, it will be printed in
normal width. This attribute remains valid until the S1 command(normal width
mode) or CAN command is received.
In the P-200 mode, this attribute is reset to normal width at the beginning of each line,
every time the line is fed.
RS, US, S1
Set Normal Width Mode or Reset Character Code
<0F>H
This command resets the double width character attribute or high page setting and prints
in normal width or normal character code.
printed in normal width or normal character code.
If double width character has been set by the S0 command, the same function as the US
command will be assumed.
RS, US, S0
If this command is received, the character
The print data received after this command is
36
iDP-460 User's Manual
This command remains valid
In the other modes,
It prints its
ALL
CITIZEN