Citizen iDP-460 User Manual page 51

BELL (D-type Only)
[Name]
[Code]
[Function]
[Caution]
ESC a (n) ;
[Name]
[Code]
[Domain]
[Function]
[Caution]
[Initial Value]
[Sample Program]
Drawer kickout
<07>H
This command outputs a designation signal to the connected drawer interface.
signal is about 200 ms.
command functions even if not connected to the drawer interface, but it is meaningless.
Connect only what is specified to the drawer interface.
activated, the main body or mating connection element may have a trouble or be
destroyed. While this command is functioning, the printer is stopping.
this command continuously.
Set Line Height
<1B>H<61H>(n)<3B>H
7 (n) 255 (<30>H
This command defines a height of each print line.
feed rate to (n-1)/3/18 inch.
A parameter(n) is 7 to 255.
minimum value of 7 assumes about 9 lines per inch, allowing no space between each line.
The line is fed in the set condition until re-setting or initialization(ESC c) is made.
initial condition is restored with "ESC a 10; 1" or an initialization command.
Be sure to add ";"(<3B>H) to the end of the parameter.
A line height for normal characters is 1/6 inch.[(n) = 10]
When setting the line height to n = 20(1/3 inch)
ESC a 20 ; LPRINT CHR$(&H1B)+"a20;";
<1B>H<61>H<32>H<30>H<3B>H
Designation is made when the solenoid is connected.
It could cause a trouble.
n <39>H)
If this value is 10, there will be 6 lines per inch.
37
iDP-460 User's Manual
Otherwise, when this function is
A dot line is 1/18 inch.
ALL
The
The
Do not specify
ALL
It sets a line
A
The
CITIZEN