6.3 Input and Output Signals
6.3.1 Input and Output Signals
(1) Input signals to the printer
DATA
STB
(2) Output signals from the printer
ACK
BUSY
FAULT
HI-LEVEL : Connected to VCC via a 3.3k
(3) Power related signal
GND
: An 8-bit parallel signal. (Positive logic)
: A strobe signal to read the 8-bit data. (Negative logic)
: An 8-bit data request signal.
signal.(Negative logic)
: A signal to indicate the BUSY status of the printer.
"LOW."(Positive logic)
: A signal turned to "LOW" when the printer has an alarm.
control circuits in the printer stop.(Negative logic)
: Common ground on the circuits
A pulse signal output at the end of the BUSY
resistor.
17
iDP-460 User's Manual
Input new data when at
At this time, all the
CITIZEN