•
Unit No.— Displays the current Stacking Master.
•
Unit No. After Reset — Indicates the stacking member elected Stacking Master after the
device is reset.
2. Define the relevant fields.
3. Click Apply. Stack management is defined, and the device is updated.
Resetting the Unit to Factory Default Mode
To reset the unit to the factory default settings, press the front panel RESET button (see figure
below.) The unit is set to Stack mode with a Unit ID of 0.
Understanding LED Indicators
Each unit contains a Master LED indicator and eight unit LEDs. The LED status definitions are
shown in the table below.
LED
Mode
Color
Solid
Green
Master
Off
N/A
Solid
Green
ID n
Off
N/A
All ports
Solid
Red
23
Description
The switch is the Stack Master.
The switch is not the Stack Master or the switch is
not stacked.
The switch is Unit ID n.
The switch is not Unit ID n or the switch is not
stacked.
The switch is powered on, but not operational.
Linksys One Ready Communications Solution
Chapter 3: Connecting the Switch
Configuring Units and Ports
3