Cisco SGE2000 Administration Manual page 48

IP Configuration
The IP Configuration screen displays these choices: the IP Address Settings, HTTP, HTTPS
Configuration, and Network Configuration of the Ethernet switch.
IP Address Configuration (Layer 2)
The IP information of the Ethernet switch is displayed here.
IP Address
Subnet Mask
Default Gateway
Management VLAN
DHCP client
IP Address Configuration (Layer 3)
The IP information of the Ethernet switch is displayed here.
IP Address
Subnet Mask
Interface Type
Interface Number
43
The IP Address of the Ethernet switch is displayed.
Verify that the address you enter is correct and does
not conflict with another device on the network.
The subnet mask of the Ethernet switch is displayed.
The IP address of your network's default gateway is
displayed.
The VLAN ID number is displayed.
The status of the DHCP client is displayed. If you
want the Ethernet switch to be a DHCP client, then
select ENABLE. If you want to assign an static IP
address to the Ethernet switch, then enter the IP
settings and select DISABLE.
The IP Address of the Ethernet switch is displayed.
Verify that the address you enter is correct and does
not conflict with another device on the network.
The subnet mask of the Ethernet switch is displayed.
The type of interface.
The number of the interface.
Linksys One Ready Communications Solution
Chapter 4: Console Configuration
Configuring the Switch through the Console or Telnet Interface
4