Reset Switch; Lan Ports - Cisco SGE2000 Administration Manual

Reset Switch

The Ethernet switch can be reset by inserting a pin or paper clip into the RESET opening. If
the reset switch is held for 10 seconds or longer, the Ethernet switch will be reset to its default
settings.
CAUTION: All user-defined settings are
lost when you hold the Reset button for
10 seconds or longer; the Ethernet
switch reverts to its default settings.
When a unit is reset to its default setting, the unit restarts in stackable mode using default
stacking ports with autonumbering enabled. Pressing the reset button on the master unit of a
stack resets all units in the stack.

LAN Ports

The Ethernet switch is equipped with 24 Ethernet ports.
1-24 The Switch is equipped with 24 auto-sensing, Ethernet (IEEE 802.3)
network ports, which use RJ-45 connectors. The Gigabit Ethernet ports
support network speeds of 10Mbps, 100Mbps, and 1000Mbps. They
can operate in half and full-duplex modes. Auto-sensing technology
enables each port to automatically detect the speed of the device
connected to it, and adjust its speed and duplex accordingly.
In stacking mode, two ports are used for stacking. By default, the
stacking ports are 12 and 24.
Ports 11, 12, 23, and 24 are shared with GBIC1, GBIC3, GBIC2,
GBIC4 respectively. If shared port pairs are both connected, then the
mini-GBIC port takes priority.
5
Linksys One Ready Communications Solution
Chapter 2: Getting to Know the Switch
The Front Panel
2