Factory Default - Cisco 5915 Technical Manual

Factory Default

Figure 7
Factory Default
To enable the factory default capability, the service declassify command must be added to the IOS
configuration file. Following are the options available for this command:
•
•
•
Table 6
Table 6
Option
erase-flash
erase-nvram
erase-all
1. The erase time of the Flash file system depends on the utilization of the Flash device. It takes more time to delete a
To start the Cisco 5915 ESR factory default process, pull the INPUT_CLEAR_L signal to GND
(Figure
deasserts (turns off). After the process is completed, the LED_CLEAR signal asserts (turns on) and the
Cisco 5915 Embedded Services Router Hardware Technical Guide
10
LED Connections
erase-flash
erase-nvram
erase-all
lists the settings and the completion time for these options.
Settings and Completion Time for Factory Default Capability Options
Target
This option erases the Flash file system
that includes the IOS images and scrubs
the main memory to ensure all code
information is removed.
This option erases NVRAM and scrubs
the main memory to ensure all code
information is removed.
This option is a superset of erase-flash
and erase-nvram options.
fully utilized file system.
8). After the process is initiated, the LED_CLEAR signal toggles (blinks) for 0.5 seconds, then
Typical Completion Time
1
6–25 minutes
18 seconds
6–25 minutes
OL-24796-01