Soft Reset Switch; Flash Disk Slots - Cisco PRP-1= Installation And Configuration Manual

Product Overview

Soft Reset Switch

Caution

Flash Disk Slots

Note
Note
Performance Route Processor Installation and Configuration Guide
16
A soft reset switch provides a reset to the processor software on the PRP. You
access the soft reset switch through a small opening in the PRP faceplate. To
depress the switch, insert a paper clip or a similar object into the opening.
The soft reset switch is not a mechanism for resetting the PRP and reloading the
IOS image. It is intended for software development use. To prevent system
problems or loss of data, use the soft reset switch only on the advice of Cisco
service personnel.
The PRP includes two Flash disk slots on the front panel of the card. Either slot
on the PRP-1 can support an ATA Flash disk or a linear Flash memory card. The
Flash disk slots on the PRP-2 can only support ATA Flash disks.
The PRP only supports +5 VDC Flash disk devices. It does not support +3.3 VDC
Flash disk devices.
All combinations of different Flash devices are supported by the PRP-1. You can
use ATA Flash disks, linear Flash memory cards, or a combination of the two.
Each Flash disk slot has an ejector button for ejecting a card from the slot. See the
"Using Flash Disks in the PRP" section on page 61
Linear Flash memory cards may not have the capacity to meet the requirements
of your configuration. However, they can be used for emergency file recovery
applications.
for more information.
OL-11656-01