Table of Contents
Advertisement
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. A MSD250 high intensity
discharge lamp is included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
Lam p In st a ll at ion
1. Remove screws (S1) and (S2) as
shown in the illustration to remove
lamp top cover.
2. Remove the 2 thumbscrews (S3) to
remove lamp lower cover as
illustrated.
3. If replacing the lamp, remove old
lamp first.
4. With a clean cloth or napkin, hold the
new lamp by the glass top end, align
the pins on the lamp with the holes in
the socket and insert the lamp
squarely until the lamp socket
secures the lamp tightly.
5. Clean the glass/envelope of the bulb
with an alcohol wipe or equivalent.
6. Replace lamp lower cover, align the
screw holes and fasten the
thumbscrews back onto the lamp
lower cover.
7. If you are replacing the lamp, you
may want to log the fixture hours in
order to track the lamps use.
Navigate to the {LPti} on the menu
display to obtain this information.
(Page 11, Control Board Functions)
8. Replace lamp top cover and fasten
with screws.
LEG-3000 Manual
1
2
S3
3,4
7
S1
S2
1
Revision: 2006-01-20/16:03
Advertisement
Table of Contents
