Table of Contents
Advertisement
10
11
12
13
14
8 Bit Movement
In the 8 bit Pan/Tilt resolution setting both (FINE) channels is removed. All other channel parameters
remain the same as in the "DMX Channel Values" table.
C
HANNEL
1
2
3
4
5
6
7
8
9
10
11
12
Dip Switches (settings explained)
D
S
IP
WITCH
All Off
1-On
2-On
1-On, 2-On
3-On
LEG-3000 Manual
Tilt
000 255
Down (0°) > Up (270°) (128 = half way point)
000 255
Pan (Fine)
000 255
Tilt (Fine)
Control
000 007
Pan/Tilt Tracking Mode
008 063
Pan/Tilt Vector Mode: Slow > Fast
064 127
Reserved
128 255
Mechanical reset after 3 seconds
Lamp ON/OFF
000 047
Standby
048 095
Hold 3 seconds for Lamp ON
096 159
Standby
160 207
Hold 3 seconds for Lamp OFF
208 255
Standby
F
UNCTION
Dimmer
Shutter
Color
Static Gobo
Rotating Gobo
Gobo Rotation
Prism
Focus
Pan
Tilt
Control
Lamp ON/OFF
E
VENT
The lamp will strike first. If striking of the lamp succeeds, in
approximately 15 seconds the fixture's motors will be powered
and initialized. If the lamp does not strike, the remainder of the
fixture will not initialize and you will not have control of the
fixture. Please wait 15 minutes before re-starting the
fixture, otherwise perform a service check.
Lamp and motors are powered at the same time.
Only the lamp will turn on in the fixture.
Only the lamp will turn on in the fixture
This switch will terminate the dmx connection.
19
Appendix
N
OTES
This is the default
setting on the fixture
and helps in reducing
the amount of striking or
inrush current used by
the fixture upon startup.
Will consume the most
amount of inrush current
in the startup phase.
Use only at the end of a
DMX daisy chain.
Revision: 2006-01-20/16:03
Advertisement
Table of Contents
