Table of Contents
Advertisement
Replacing gobos
1. Begin to remove the fixture top cover
by loosening the screws labeled (S1)
on the lamp heat plate located at the
rear of the head of the fixture.
2. Remove the heat plate to expose
reflector and additional screws.
3. Remove screws labeled (S2).
4. Rotate the head and remove
screw (S3) from the front of the
fixture.
5. Press both tips of the gobo tension
ring together and remove from the
gobo aperture.
6. Push the gobo with your finger from
the back side following the same
direction that the tension ring was
removed.
NOTE!
Replacing the gobos on the static
gobo wheel of the Legend™ 3000X is
achieved using the same method as
the rotating gobo wheel. However,
the spring needs to be removed first
using a small flat head screw
driver before pushing the
gobo out of the aperture.
LEG-3000 Manual
1
2
Cover removed
Gobo tension ring
9
S1
S2
S3
4
5,6
Revision: 2006-01-20/16:03
Advertisement
Table of Contents
