Capital Performance Series PSQ30RBI Use And Care Manual page 28

caring for your grill
part 2
STAINLESS STEEL CARE:
The grill is constructed out of 304
stainless steel which is a
non-magnetic stainless steel.
After initial usage, areas of the
grill may discolor from the intense
heat given off by the burners: this
condition is normal. There are
many different stainless steel
cleaners available on the market.
Always use the mildest cleaning
procedure first, scrubbing in the
direction of the grain. To touch
up noticeable scratches in the
stainless steel, sand very lightly
with dry 100 grit emery paper in
the direction of the grain. Specks
of grease can gather on the
surfaces of the steel and bake on
to the surface giving a "rust-like"
appearance. For removal, use
an abrasive pad in conjunction
with a stainless steel cleaner.
Always rub in the direction of
the grain.
REPLACING THE LIGHTS:
1. Carefully wedge a flat tipped
screwdriver between the back glass of
the light cover and the rotisserie back
panel as shown below.
2. Access the bulb and carefully pull
out to remove.
3. Replace bulb with a new one.
24
CARING FOR YOUR GRILL BURNER:
Remove the grill grates, then lift out the
radiant trays. Grasp the burner and pull it up
carefully and slightly towards the rear wall of
the unit so the burner head comes off the
brass orifice at the front. Angle the burner
sideways and remove.
(Fig. 17 and 18)
Clean the burner exterior with a wire brush.
Clear stubborn scale with a metal scraper.
Clear any clogged ports with a straightened
paper clip. Never use a wooden toothpick as
it may break off and clog the port. Shake out
any debris through the air shutter. Use a
flashlight to inspect the burner inlet to ensure
it is not blocked. If obstructions can be seen,
use a metal wire coat hanger that has been
straightened out.
WARNING!
Make sure burner is cool before
removing for cleaning.
Fig. 17
Fig. 18