Locating Grill - Capital Performance Series PSQ30RBI Use And Care Manual

locating grill

PSQ30 =37"
PSQ40 =47"
PSQ52 =59"
USING ROTIS MOTOR
PSQ30 =30"
PSQ40 =40"
PSQ52 =52"
W/O ROTIS MOTOR
PSQ52RCSB
8
NOTE: For combustible enclosures grills MUST be installed with an insulated jacket!
Use of insulated jacket requires alternate cutout dimensions.
GENERAL:
The grill is designed for easy placement into
non-combustible masonry enclosures. For non-combustible
applications the grill drops into the opening shown in Fig 5
and hangs from its side flanges. A deck is not required to
support it from the bottom.
12" clearance on
sides to combustibles
9 3/4"
25-3/8"
27-1/4"
29"
LOCATION:
When determining a suitable location, take into
account concerns such as exposure to wind, proximity
to traffic paths, and keeping any gas or electrical supply
lines as short as possible. Locate the grill only in a
well-ventilated area. Never locate the grill in a building,
garage, breezeway, shed or other such enclosed areas
without an approved ventilation system. During heavy use,
the grill will produce a lot of smoke. Ensure there is
adequate area for it to dissipate.
IMPORTANT:
A minimum of 12" clearance from the sides and a minimum
of 6" from the back must be maintained from the grill above
and below the cooking surface to adjacent vertical
combustible construction. See Fig 6 on next page.
grill exhaust
4" clearance for top lid
22-3/4"
8-3/4"
SUPPORT FLANGE
Fig 5