Lighting The Rotisserie - Capital Performance Series PSQ30RBI Use And Care Manual

lighting the rotisserie

NOTE:
The location of the rotisserie
burner makes it more
susceptible to strong wind
conditions, more so than the
protected grill burners.
For this reason you should
avoid operating the rotisserie
during windy conditions. As
an added safety feature
we've equipped the burner
with an automatic safety
valve that will not allow gas
to flow to the rotisserie
burner unless the following
conditions are present with
the knob on:
1. The safety valve button is
pressed and held down.
2. The safety valve
thermocouple has been
sufficiently heated to keep
safety valve open.
17
WARNING:
Keep hands and face away from
front of burner! STAND TO THE SIDE
WHEN LIGHTING. ONCE LIT MOVE
HAND AWAY QUICKLY!
LIGHTING THE ROTISSERIE BURNER:
The safety valve on all Performance Series™
rotisserie sections is included in the main burner
valve. No separate safety button is necessary to
operate the rotisserie safety feature.
Open the lid. Push and turn the control valve to "HI", keeping
knob pushed in and wait 5 seconds. Push igniter button and hold
until rotisserie burner lights. You'll hear a "ticking" sound. Once lit
keep knob pushed and held in position for 5 seconds and DO
NOT release the control knob once burner is lit. After 5 seconds
set the knob to desired setting. If the burner does not light within
4 to 5 seconds, release the safety valve button and turn the
control knob to "OFF"Wait at least 5 minutes before trying again.
• If relighting a hot burner, wait 5 minutes.
• Never leave the control knob ON if rotisserie
is not in use.
• Never light a grill burner under the rotisserie
while rotisserie burner is lit.
MANUAL LIGHTING:
To manually light the rotisserie, place a
butane lighter near the tip of the
thermocouple. Turn the control knob to
"HI." Hold the safety valve button in for
about 4 to 5 seconds or until the burner
remains lit. Once lit, turn control knob to
desired setting. If the burner does not
light within 4 or 5 seconds, release the
safety valve button and turn the control
knob to "OFF" and wait 5 minutes before
trying again.