Table of Contents
Advertisement
Assembling the jack
Assemble pump lever 1.
#
Place pump lever
1
with the recess on low‐
#
ering screw
2
on the jack.
Turn pump lever
1
clockwise as far as it will
#
go.
Lowering screw
2
is closed.
3
Adapter
To raise the vehicle at the front: adapter
must be secured on the jack.
To raise the vehicle at the rear: remove
adapter
3
from the jack.
Important notes on using the jack:
Use only the vehicle-specific jack that has
R
been tested and approved by Mercedes-Benz
to raise the vehicle.
The jack is only designed for raising and
R
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large,
flat, load-bearing, non-slip underlay.
Position the jack only at the jack support
R
point.
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the
R
vehicle.
Never lie under the vehicle.
R
Do not start the engine and do not release
R
the electric parking brake.
3
Do not open or close any doors or the rear-
R
end door.
Wheels and tires 381
Advertisement
Table of Contents
