Table of Contents
Advertisement
150 Driving and parking
Press and hold button 1,
2
or
#
wish to program.
Indicator lamp
4
flashes yellow.
%
It can take up to 20 seconds before the indi‐
cator lamp flashes yellow.
Release the previously pressed button.
#
Indicator lamp
4
continues to flash yellow.
Point remote control
5
from a distance of
#
0.4 in (1 cm) to 3 in (8 cm) towards button
1,
2
or 3.
Press and hold button
6
of remote control
#
5
until one of the following signals appears:
Indicator lamp
4
lights up green contin‐
R
uously. Programming is complete.
Indicator lamp
4
flashes green. Pro‐
R
gramming was successful. Additionally,
synchronization of the rolling code with
the door system must also be carried out.
If indicator lamp
4
does not light up or flash
#
green: repeat the procedure.
Release all of the buttons.
#
3
that you
%
The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Synchronizing the rolling code
Requirements:
The door system uses a rolling code.
R
The vehicle must be within range of the
R
garage door or door drive.
The vehicle as well as persons and objects
R
are located outside the range of movement
of the door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or
3
repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
%
Please also read the operating instructions
for the door drive.
Troubleshooting when programming the
remote control
Check if the transmitter frequency of remote
#
control
5
is supported.
Replace the batteries in remote control 5.
#
Hold remote control
5
at various angles
#
from a distance of 0.4 in (1 cm) to 3 in
(8 cm) front of the inside rearview mirror.
You should test every position for at least
25 seconds before trying another position.
Hold remote control
5
at the same angles
#
at various distances in front of the inside
rearview mirror. You should test every posi‐
tion for at least 25 seconds before trying
another position.
On remote controls that transmit only for a
#
limited period, press button
2
control
5
again before transmission ends.
Align the antenna line of the door opener unit
#
with the remote control.
6
on remote
Advertisement
Table of Contents
