Canon BJC-S300 Quick Start Manual page 11

The S300 can print on paper ranging from
standard copier paper (usually 17–28 lb.)
to specialty media paper and envelopes.
The paper thickness lever is located
inside the front cover, on the printhead
holder. It controls the paper feed for the
type and weight of the media on which
you are printing.
For envelopes (see "To load
envelopes" on page 6), banners and T-Shirt Transfers.
For regular paper and other media with a left position in the table (see
"Load Limit and Paper Thickness Lever Position" on page 4).
Use the chart on the previous page to ensure that the paper thickness lever is
set correctly for the type of media you are using.
T T o o l l o o a a d d p p a a p p e e r r o o r r o o t t h h e e r r m m e e d d i i a a : :
1. Make sure the paper thickness lever is
set correctly for the media used.
2. Slide the paper guide completely to the left.
3. Fan the edges of the sheets to remove
static cling and avoid paper jams, then
tap the edges of the stack against a flat
surface so the stack is aligned.
4. Insert the media into the paper rest,
with the print side facing up.
Some papers, especially
specialty media, have
specific sides for printing.
The print side is usually the glossier side or the brighter white
side. When using specialty media, do not touch the print side.
5. Slide the paper guide to the edge of the media until it is firmly in place.
You can load up to 100 sheets of plain (17 lb.) paper or 80
sheets of Canon High Resolution Paper in the paper rest at one
time. Never load the paper above the load limit mark.
Basic Printing
Print side
Load limit mark
5 5