Nortel Meridian 1 Manual page 132

Page 118 of 190 Clearing network equipment faults
Possible cause
Defective
conference/TDS
card
Excessive traffic in
the system
553-3001-510 Standard 11.00 June 1999
Action
Test Tone and Digit Switch loops by entering:
LD 34
TDS loop "loop" represents the loop number.
If the conference loop is disabled, try to enable it by entering:
ENLX loop "loop" represents the TDS/MFS loop, which is the even
loop of the Conference/TDS loop pair).
Note: You must enable the card with the command ENLX. Enabling the loops with
the command ENLL does not enable the hardware.
If a fault is indicated on a conference loop, replace the conference/TDS
card identified.
If no faults are detected on any conference loop, go to the next possible
cause.
Additional digitone receivers or conference/TDS cards may be required to
handle the traffic in the system. See Traffic measurement formats and
output (553-2001-450).