Model Id - FUTABA T16IZ Short Manual

Model ID

For the sake of safety, this function does not operate the receiver if the model data of the model program
settings that does not match the aircraft is used by mistake.
Conventional system
Select Model 2
It works with different model data.
There is a risk of flying with different model data !
Link is required when a new model is made from a model selection.
Select a model in Model Select. Link with a receiver that matches the model.
■ In the system types (FASSTest, T-FHSS) compatible with the model
ID function, a unique ID number (model ID) is set to each model
data. Linking with a receiver stores the model ID of the model data
in that receiver. The receiver operates only when it receives radio
waves transmitted using model data that matches the stored model
ID. As a result, the receiver does not operate even if model data of an
unintended setting is used by mistake, so it is possible to prevent a
malfunction due to a model selection mistake.
■ If you want to use different model data from the model data that you
have been using, link again.
Rx 1
Operation
Rx 2
Operation
Operation Rx 3
Add new model data
1: Model 1
2: Model 2
3: Model 3
1: Model 1
2: Model 2
3: Model 3
1: Model 1
2: Model 2
3: Model 3
FASSTest, T-FHSS
Model ID
Not Operation
Operation
Not Operation
Select Model 2
Model 2 only works with Model 2 data.
There is no risk of flying with different model data.
Model 1 Receiver
Link
Model 2 Receiver
Link
Model 3 Receiver
Link
■ Model ID feature is enabled only if the system type is FASSTest or
T-FHSS. Please note that model ID function can not be used on other
systems.
■ For safety reasons, model ID function can not be disabled.
■ Model data that can be stored in internal memory is up to 250
models.
■ Model ID is automatically set when copying or adding model data.
■ R3004SB receiver does not support model ID function. When using
the R3004SB, set "Receiver" in the system type screen T-FHSS
mode setting to [R3004SB]. When using other T-FHSS compatible
receivers, set "Receiver" to [Normal].
Rx 1
Rx 2
Rx 3
29