Table of Contents
Advertisement
Table 6-2 Switch Configuration: Port Configuration
L
D
AB E L
E S C R I P T I O N
Pause Flow Ctrl
This field displays whether flow control is activated.
Trunking
This field displays whether the port is a member of the trunk group.
Apply
Click Apply to save the changes.
6.2.1.
Trunk Group Setting
You can configure up to four trunk groups on the switch. In the Port Configuration screen,
right-click and click Trunking > Enabled to activate trunking on the selected port. A Trunk
Setting screen displays as shown. The screen displays the port numbers belonging to the
trunk group.
Select the trunk speed. Make sure the peer device to which this trunk connects is also set to
use the same speed. Click OK to save the setting and close this screen.
Figure 6-3 Switch Configuration: Port Configuration: Trunk Setting
6.2.2.
VLAN and Trunking
Ports in the same trunking group must belong to the same VLAN group. If you set the trunk
port members to be in different VLAN groups, a warning screen displays when you enable
trunking in the Port Configuration screen.
Click Yes in the warning screen to display the Port-based VLAN Configuration or the
802.1Q VLAN Configuration screen and change the VLAN settings. Refer to Section 6.5. for
more information on VLAN.
Smart Ethernet Switch Series User's Manual
33
Advertisement
Table of Contents
