Table of Contents
Advertisement
Do NOT connect a telecommunication cable to the fiber port.
To avoid risk of severe eye damage, do NOT look into an operating fiber port
2.4.2.
Power Connection
The power socket is located on the rear panel of the switch. Use the power cord to connect
this socket to a power source to power on the switch.
Use the power source as labeled on the rear panel.
Figure 2-6 Rear Panel
2.5. LED Description
The following table describes the LEDs on the front panel.
Table 2-3 LED
L
S
E D
TAT U S
PWR
On
Off
LNK/ACT
On
Blinking
Off
and/or fiber connector.
D
E S C R I P T I O N
The smart switch is receiving power.
The smart switch is not receiving power.
The port is connected and is transmitting data.
The port is connected and is transmitting data.
The port is not connected.
12
Smart Ethernet Switch Series User's Manual
Advertisement
Table of Contents
