Bushnell Trail Scout 11-9833 Instruction Manual page 15

OThER SETUp nOTES
1. SD CARD SLOT
The unit has a standard SD Card slot. You must push the SD Card in with the SD Card label facing the
Bushnell logo into the SD card slot. Pushing it again will release the SD card, and then you can remove the
SD card from the SD card slot. insertion or removal of SD card is only recommended when the unit is in
the "OFF" position.
2. PIR SENSOR
The sensor that triggers the trail camera is Passive infraRed, or PiR. infrared energy is essentially heat
energy. The PiR detector operates by sensing a change in the infrared level in its detection zone. This zone
is a cone in the center 10 degrees of the camera's field of view. The camera establishes an average long-term
infrared level. When this level increased suddenly the PiR detector signals the camera to record a picture
and/or an event. Because of this effect, the PiR detector will be more sensitive at night, when the average
temperature is lower.
in the Setup mode, you can use PiR sensor to determine the detection zone .When the PiR is sensed, the
PiR Sense indicator will light. The camera's field of view is a 45 degree cone, centered on the PiR detection
zone.
1
Trail Scout 2007 Models 119833+115 15 5/29/07 11:08:33 PM