Table of Contents
Advertisement
3.8.4 Seating Control
Seating Mode can be entered from the User Menu via an
operation of the User Switch, (Fig. 3.5)
Fig. 3.5
User Menu
Seating
Drive
Speed Adjust
Horn
Lights
Settings
Sleep
Exit
The OMNI2 will sequentially scan though each available
actuator 'axis', and then finish with an 'Exit' option, (Fig. 3.6),
to return to Drive, the User Menu or the next sequential
function.
Fig. 3.6
SEAT LIFT
Exit
16
If the User Switch is operated when one of the actuator axes
are shown, a new scanning sequence will begin.
The OMNI2 will step through, 'up', 'down' and 'exit', (Fig. 3.7)
choices. Each option can then be selected with an operation of
the User Switch.
Fig. 3.7
Up
Down
The scanning rate of the actuator axes is set to approximately
1 second and cannot be altered through programming.
3.8.5 Speed Adjust Mode
A Speed Adjust Mode screen as shown in Fig. 3.8, will appear
if the User Control parameter has been set to Sequence, (Refer
to section 2.15).
Fig. 3.8
WARNING:
It is not advisable to program the menu option, 'speed
adjust' if the Sequence method is being used with a
Single Switch Scanner-Type SID. Refer to your health care
professional or servicing agent
Exit
OMNI2
Rev.A
Advertisement
Table of Contents
