Settings Menu - Sunrise Medical QUICKIE OMNI2 Instructions For Use Manual

SID Displaced
If the SID is operated before or just after you switch the control
system on, the screen will flash the joystick displaced screen.
You must release and center (where applicable) the SID to
resume normal operation. If you do not release the SID within
five seconds the powerchair will not be able to move, even
if you release the SID and operate it again. The screen will
display a diagnostic screen at this time. You can reset this
condition by switching the OMNI2 off and on again.
22
5.0

Settings Menu

The Settings Menu allows access to user-related adjustments.
It can be accessed from the User Menu or by pressing the top
right-hand soft-key on the Display Section after the OMNI2 has
been switched on. A typical Settings Menu display is shown in
Fig. 5.0.
Fig. 5.0
Settings
Time
Distance
Backlight
Bluetooth
IR Setup
Programming
Exit
SID forward and reverse movements are used to navigate up
and down the screen.
Set Time
A right SID deflection will enter a sub-menu with the following
time-related function options:
Set Time – allows you to set the current time and date.
Display Time – this sets the format of the time display or turns
it off. The options are 12hr, 24hr or Off.
Distance
A right SID deflection will enter a sub-menu with the following
odometer data and function options:
Total Distance –this is a value held in the Power Module and
relates to the total distance driven using that Power Module.
Trip Distance – this is a value held in the OMNI2 and relates to
the total distance driven since the last reset.
Display Distance - this sets whether Total Distance or Trip
Distance appears as the odometer display on the OMNI2.
Clear Trip Distance – a right SID deflection will clear the Trip
Distance value.
OMNI2 Rev.A