Olivetti PR 4 Programmer's Manual page 92

ESC c 3 n
Select paper sensor(s) to output paper end signal
Hexadecimal code: 1B 63 33 n
Range: n = 1-255
Selects the paper sensor(s) used to output paper end signal, using n as follows:
Bit Off/On Hex
0 Off 00
On 01
1 Off 00
On 02
2 Off 00
On 04
3 Off 00
On 08
4 Off 00
On 10
5 Off 00
On 20
6-7 - -
Notes: - It is possible to select multiple sensors to output signals. Then if any sensor detects a
paper end, the paper end signal is output.
- This command is available only with a parallel interface and is ignored with a serial
interface.
n = 15
Default:
6-6
Decimal Function
0 Journal near end sensor disabled.
1 Journal near end sensor enabled.
0 Receipt near end sensor disabled.
2 Receipt near end sensor enabled.
0 Journal sensor disabled.
4 Journal sensor enabled.
0 Receipt sensor disabled.
8 Receipt sensor enabled.
0 Slip insertion sensor disabled.
16 Slip insertion sensor enabled.
0 Slip ejection sensor disabled.
32 Slip ejection sensor enabled.
- Undefined.
Epson TM-U950P Commands