Remote Commands - Brother FAX 2600 Operation Manual

Remote Commands

Follow the commands below to access features remotely. When you call the
FAX/MFC and enter your Remote Retrieval Access Code (1 5 9
will signal you with two short beeps to enter a remote command.
Remote Commands
95 Changing Fax
Forwarding / Paging
setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve a fax
1 Memory Status List Enter the number of a remote fax machine to
2 Retrieve all faxes
3 Erase fax from the
memory
97 Check the Receiving
Status
1 FAX
98 Change Receive
Mode
1 TAD
2 FAX/TEL
3 FAX
90 Exit
8 - 4
R E M O T E F A X O P T I O N S
Operation Details
If you hear one long beep, the change is
accepted. If you hear three short beeps, you
cannot change it because the conditions have not
been met (Example: registering paging number).
You can register your fax forwarding number by
using 4. FAX FWD NO (see p. 8-1). Once you
have registered the number, the FAX/MFC will
change automatically to FAXFWD:ON mode.
Then retrieve a Memory Status List by entering
961 (see p. 8-5) to make sure that the Fax
Forwarding number you registered is correct in
the List.
You can set FAX STORAGE to ON or OFF.
receive the Memory Status List or stored fax
message(s). (See p. 8-5)
If you hear one long beep, you can erase fax
message(s) from the memory.
You can check whether your FAX/MFC has
received any faxes. If yes, you will hear one long
beep. If no, you will hear three short beeps.
If you hear one long beep, you can change the
Receive Mode. If you hear three short beeps, you
cannot change it.
After a long beep, you can exit remote access.
), the system