Troubleshooting - GBC 5031TS ROLL Instruction Manual

GBC 5031TS

TROUBLESHOOTING

FEEDER
PROBLEM
Will Not turn on.
Motor(s) not turning
Pick-up heads not lifting the
sheets
Pick-up heads are dropping
the sheets before they clear
the separator bar.
Pick-up heads dropping the
sheets before they reach the
feed tires
Inconsistent gap between the
sheets
Sheets bunching up as they
are being pulled into the
laminator
LAMINATOR
PROBLEM
Will not turn on
Motor not turning
Rewind Tube not rotating
No heat
© 2006 General Binding Corporation
CAUSE
No Power
E-STOP is engaged.
Blown fuse(s).
Main Vacuum valve not open
Flow adjustment on the air pump
not open enough.
Air Pump varies are clogged
Pick-up heads are closed
Losing vacuum in the system
Pile height may not be set
correctly
Paper grain of the sheets is
causing the pick-up heads to drop
the sheet at the separator bar.
Side guide and/or rear stops are
too tight against the stack
Vacuum regulator may be out of
time.
Sheets slipping on the feed
rollers.
Too much in-feed pressure
CAUSE
No Power
Blown fuse(s)
E-STOP is engaged
Safety Shield not latched
Top Heat Shoe not closed
Clutch is too loose
Heat set too low
Open TCO
Burned out heater
OPERATION MANUAL
SOLUTION
Check the power cord at the wall.
Disengage E_STOP
Replace fuses(s)
Open valve
Check adjustment on the air pump
Clean the air pump
Open pick-up heads
Check the hoses and connections.
Adjust pile height switch
Adjust the pile height switch or turn
the sheets 90 degrees.
Loosen the side guides and/or rear
stops
Have a qualified technician check
the vacuum timing.
Adjust the feed tire pressure
Clean the feed rollers and feed
tires
Switch from ball bearing rack to
secondary feed tire(s)
Reduce the number of ball bearing
Reduce the pressure on the
secondary in-feed tire(s)
SOLUTION
Check the power cord at the wall
Replace fuse(s)
Disengage E-STOP
Check right and left safety shield
latches
Check the position of the Top Heat
Shoe
Tighten the rewind clutch
Check heat settings on the Control
Panel
Have a qualified technician check
the unit
Have a qualified technician check
the unit
26