Troubleshooting - GBC FOTON 30 Start Here Manual

TROUBLESHOOTING

SYMPTOM
Pressing the Power
button does not turn the
machine ON
Status Indicator Red:
Film Wrinkles on output
Film Edges are not evenly
aligned.
10
POSSIBLE CAUSE
The power cord may not
be inserted all the way
into outlet
Door Error Indicator Red:
Paper Jam Error Indicator
Red:
Film Empty Indicator Red:
Cutter Error Indicator
Red:
Film Misaligned
Top and bottom rolls of
film are not matched
properly.
CORRECTIVE ACTION
Fully Insert plug into outlet.
Make sure the outlet has power.
Remove any paper from the feeder tray. Open and Close
both the laminator door and the feeder door. Ensure they are
fully closed
Remove any paper from the feeder tray. Open and close the
feeder door.
If the above does not clear the error, press and hold the RUN
button for 10 seconds to manually feed film. Film should
begin to exit the machine and Jam should clear.
If Jam error remains, open laminator door and look to see if
film leader is caught on an obstacle or the rollers. DO NOT
CUT the film. Lift-up the film leader and replace it in proper
position. Shut Laminator door and hold the run button for 10
Seconds.
Cartridge End of Roll label has been detected. Replace the
film cartridge with new cartridge and shut the laminator door.
Press the manual cut button one time to try and activate the
cutter. Not resolved, try the following:
Press and hold the RUN button for about 10-20 seconds to
manually advance the film. If there is laminated media in the
exit of the laminator, hold the RUN button until the media has
fully exited the laminator. Now press the manual cut button to
see if the cutter is activated.
If the film does not run, or if the cutter does not work after the
above steps, contact your service provider.
Press and hold the RUN button to manually advance the film.
After 125 – 500mm of film has been advanced the wrinkle
should work themselves out. If wrinkle clear press the manual
cut button and you are ready to begin.
If wrinkles still present, open the laminator door. Grasp the
film exiting the laminator and hold it taut while closing the
laminator door. Repeat above step and wrinkles should
disappear.
Press and hold the RUN button to manually advance the
film. After 125 mm of film has been advanced the film edges
should be evenly aligned. If film edges are now evenly
aligned, press the CUT button and you are ready to begin.
If film edges are still not evenly aligned, open the laminator
door. Grasp the film exiting the laminator and hold it taut
while closing the laminator door.