GBC 5031TS
CUTTER
PROBLEM
Will not turn on
Motor(s) not turning
Rear cut is angled
Not cutting
Finished margins don't match
settings
© 2006 General Binding Corporation
CAUSE
No Power
Safety Shield not latched
Blown fuse(s)
Output roller guides not lined up
properly
Sheet sensor not working
In-feed Rollers are dirty
Calibration is off
OPERATION MANUAL
SOLUTION
Check the power cord at the wall
Check the Safety Shield latches
Replace fuse(s)
Adjust the Output Roller Guides
Have a qualified technician check
the unit
Clean in-feed rollers
Have a qualified technician check
the unit.
27