Swing-Out Feeder - GBC 5031TS ROLL Instruction Manual

Table of Contents

Advertisement

GBC 5031TS
FEEDER CONTROLS
Figure 8
Figure 9
Figure 10
© 2006 General Binding Corporation
A. Rear Guides:
Reversible for longer sheets.
B. Side Guides:
These are adjusted to keep the sheets from
floating. They should be snug to the sheets, but
not too tight or they will prevent the sheets from
feeding properly.
Warning: Do not stack anything on the
B
Feed Table other than the sheets
intended to be laminated. Make sure the
A
sheets are directly under the Pile Height
box before turning on the laminator.

SWING-OUT FEEDER

A. Left Feeder Latch (Figure 9)
Both latches MUST be disengaged before
A
swinging out the feeder.
A. Right Feeder Latch (Figure 10)
A
Swing out feeder to load bottom film roll.
OPERATION MANUAL
(Contd.)
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

1711718

Table of Contents