Table of Contents
Advertisement
44DT
T
ROUBLESHOOTING
Symptom
Power lamp does not
illuminate (next to the
stop button when the
power switch is in the ON
position.
Rollers do not turn.
Laminated items are
curling.
Adhesive deposited on
rollers.
Unsatisfactory laminate
adhesion.
Page 7-2
Possible Cause
Laminator not connected to electrical
supply.
Fuse blown out.
Safety shield not seated properly.
Feed tray interlock latch not in place.
Tension between the top and bottom film
roll is unequal.
Tension on top or bottom roll of film is too
loose.
Grippers on core adaptors pointing in the
wrong direction.
Speed setting too slow.
Top and bottom film webs not aligned.
Laminate improperly loaded.
Speed setting too fast for type of material
being laminated.
Laminate improperly loaded.
Rollers require cleaning.
Laminated item unsuitable for adhesion.
Operating Instructions
Corrective Action
Insert attachment plug into receptacle.
Replace fuse or contact your dealer/
distributor for assistance.
Lower safety shield.
Slide interlock latch all the way to the left
into the side frame.
Adjust tension per Film Tension section.
Adjust tension per Film Tension section.
Load film per Loading Film Onto the Supply
Shafts section.
Slightly speed up laminator.
Align film webs per Film Alignment section.
Load film per Loading Film section.
Lower speed setting by turning the speed
knob to slower Speed.
Load film per procedure outlined per
Loading Film section
Clean rollers per Cleaning the Rollers
section.
Item may be dirty or may have non-
porous surface that is extremely difficult
to laminate.
Advertisement
Table of Contents
