GBC 5031TS ROLL Instruction Manual page 17

GBC 5031TS
DUAL FEED DELIVERY SYSTEM
Figure 30
Figure 31a
Figure 31b
Figure 32
© 2006 General Binding Corporation
Thumbscrew
Feed arm
Thumbscrew
(Use this screw to attach
feed tire to the feed arm)
Rack
Remove these knobs
and place in the Ball
Bearing Tray
Install one or two feed
tires. Center to sheet
being fed.
Note: Feed Tires need to be attached to the inside
of the feed arms
OPERATION MANUAL
4. Remove the two thumbscrews that
hold the rack to the feed arms,
(Fig. 30).
5. Loosen the two knobs, on each side of
the frame that hold the feed arm
assembly up (Fig. 31a & 31b). They do
not have to be completely removed.
6. Loosen the thumbscrew on the right
side feed arm and slide it to the center
of the bar, (Fig 30).
7. Attach the feed tire to the feed arm
using one of the thumbscrews from the
rack, (Fig. 32). If necessary, install two
secondary feed tires
8. Reposition the feeder.
The pressure of the secondary feed tire can me
adjusted using the thumbscrew on the feed arm
that has the spring on it.
(Contd.)
16