Auto Tuning Storage (Ats) - Tecsun PL-330 User Manual

Auto Tuning Storage (ATS)

Automatically tune into and store FM, LW, MW and SW stations
Operation for FM and MW/LW:
1) Quick press [ FM ] or [ MW/LW ] to select the frequency band.
2) Press and hold the [ FM ] or [ MW/LW ] button until "PRESET" flashes and
the frequency starts running.
3) When the frequency stops running, it means the ATS operation has been
completed. Rotate the [ TUNING ] knob to view all the stored stations.
Operation for SW:
There are two ATS modes for SW:
Mode A: Press and hold the [ < ] button to initiate ATS within all meter bands.
Mode B: Press and hold the [ > ] button to initiate ATS within the selected
meter band.
Tips:
ATS (except in SW mode B) replaces previously stored radio stations. To
prevent this from happening, please consider using ETM+ (see page 12).
ATS results for LW, MW and SW strongly depend on radio wave propagation
conditions, the receiving environment and other factors. If the results are
poor, try to initiate ATS at a different location and/or time, or tune into
stations manually and then store them.
For better ATS results in the LW, MW and SW bands, please also review the
tips for ETM+ on page 14.
9
.
www.tecsunradios.com.au